Filter
Top Products
Version Description
9.7(0.0) Removed the in and out parameters. Introduced on the
S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.0 Introduced on the E-Series.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Related
Commands
ip access-list extended — configure an access list based on IP addresses or
protocols.
ip pim ingress-interface-map
When the Dell Networking system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list Enter the name of a standard access list.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
1380
PIM-Sparse Mode (PIM-SM)