Filter
Top Products
Without a cluster ID, the route reflector cannot recognize route updates from the
other route reflectors within the cluster.
The default format for displaying the cluster-id is dotted decimal, but if you enter
the cluster-id as an integer, it is displayed as an integer.
Related
Commands
• bgp client-to-client reflection – enables route reflection between route
reflector and clients.
• neighbor route-reflector-client – configures a route reflector and clients.
• show ip bgp cluster-list – views paths with a cluster ID.
bgp confederation identifier
Configure an identifier for a BGP confederation.
Z9500
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation
identifier as-number command.
Parameters
as-number Enter the AS number. The range is 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems. The next hop, MED, and local
preference information is preserved throughout the confederation.
The system accepts confederation EBGP peers without a LOCAL_PREF attribute.
The software sends AS_CONFED_SET and accepts AS_CONFED_SET and
AS_CONF_SEQ.
510
Border Gateway Protocol