Filter
Top Products
Defaults threshold = 75
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than the
neighbor maximum-prefix command
configuration allows, the neighbor goes down and the
show ip bgp summary
command displays (prfxd) in the State/PfxRcd column for that neighbor. The
neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name
} next-hop-self command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
Border Gateway Protocol
421