Filter
Top Products
Defaults Disabled
Command
Modes
CONFIGURATION
Example
Dell(conf)#feature udf-acl
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500.
key
Configure UDF data context for parsing the different header location offset and required bytes.
Syntax
key description udf-id id packetbase PacketBase offset bytes
length bytes
To return to the default settings, use the no key description udf-id id
packetbase PacketBase offset bytes length bytes command.
Parameters
description Enter the key name for reference, up to 64 characters.
udf-id id Enter the keywords udf-id then the ID used in the actual
UDF ACL group. The range is from 1 to 12.
packetbase
PacketBase
Enter the keyword packetbase then the option to refer to
start of packet offset. The options are:
• innerL3Header — Offset is at inner L3 header.
• innerL4Header — Offset is at inner L4 header.
• outerL3Header — Offset is at outer L3 header.
• outerL4Header — Offset is at outer L4 header.
• packetStart — Offset is at packet start.
offset bytes Enter the keyword offset then the offset value. The range is
from 0 to 126, in multiples of 2.
length bytes Enter the keyword length then the length value. The range
is from 2 to 24, in multiples of 2 bytes.
Defaults None
Command
Modes
CONFIGURATION-UDF TCAM
338
Access Control Lists (ACL)