Filter
Top Products
With the not-advertise parameter configured, you can use this command to
filter out some external routes. For example, if you want to redistribute static routes
to OSPF, but you don't want OSPF to advertise routes with prefix 1.1.0.0, you can
configure the summary-address 1.1.0.0 255.255.0.0 not-advertise to filter out all
the routes fall in range 1.1.0.0/16.
Related
Commands
area range — summarizes routes within an area.
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
Z9500
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to
4294967295. The default is 5 seconds.
holdtime Enter a number as the hold time. The range is from 0 to
4294967295. The default is 10 seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
1330
Open Shortest Path First (OSPFv2 and OSPFv3)