Filter
Top Products
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp keepalives
Display information about BGP keepalive messages.
Z9500
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] keepalives [in | out]
To disable debugging, use the no debug ip bgp [A.B.C.D | X:X:X:X::X |
peer-group
peer-group-name] keepalives [in | out] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display BGP keepalive information corresponding
to that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
398
Border Gateway Protocol