Filter
Top Products
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults Not configured.
Command
Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
Use the order option only when you use policy-based QoS on the switch. For
more information, refer to the Quality of Service chapter of the Z9500
Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
Use the monitor option only when you are using flow-based monitoring. For
more information, refer to the Port Monitoring chapter of the
Z9500 Configuration
Guide.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Related
Commands
deny tcp — assigns a filter to deny TCP packets.
deny udp — assigns a filter to deny UDP packets.
Access Control Lists (ACL)
235