Filter
Top Products
Version Description
6.5.1.0 Introduced.
Usage
Information
The max-hops command is a configuration command that applies to both the IST
and all MST instances in the MSTP region. The BPDUs sent out by the root switch
set the remaining-hops parameter to the configured value of max-hops. When a
switch receives the BPDU, it decrements the received value of the remaining hops
and uses the resulting value as remaining-hops in the BPDUs. If the remaining-
hops reach zero, the switch discards the BPDU and ages out any information that it
holds for the port.
msti
Configure multiple spanning tree instance, bridge priority, and one or multiple VLANs mapped to the MST
instance.
Z9500
Syntax
msti instance {vlan range | bridge-priority priority}
To disable mapping or bridge priority, use the no msti instance {vlan range
| bridge-priority priority} command.
Parameters
msti instance Enter the MSTP iInstance. The range is from zero (0) to 63.
vlan range Enter the keyword vlan then the identifier range value. The
range is from 1 to 4094.
bridge-priority
priority
Enter the keywords bridge-priority then a value in
increments of 4096 as the bridge priority. The range is from
zero (0) to 61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480,
24576, 28672, 32768, 36864, 40960, 45056, 49152, 53248,
57344, and 61440. All other values are rejected.
Defaults default bridge-priority is 32768.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Multiple Spanning Tree Protocol (MSTP)
1239