Filter
Top Products
Parameters
int-count Enter the keyword count to indicate the number of required
debug messages.
interface type Enter the following keywords and slot/port information:
• For a 10G Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40G interface, enter the keyword fortyGigE then
the slot/port information.
• For a management interface, enter the keyword
managementinterface then the slot/port information.
• For a port-channel interface, enter the keywords port-
channel then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
slot/port information.
Default Disabled
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage
Information
To debug the MLD protocol for all ports or for specified ports, use the debug
ipv6 mld_host command. Displayed information includes when a query is
received, when a report is sent, when a mcast joins or leaves a group, and some
reasons why an MLD query is rejected.
ip multicast-limit
To limit the number of multicast entries on the system, use this feature.
Z9500
Syntax
ip multicast-limit [vrf vrf-name] limit
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to limit the number of multicast on the VRF.
1214
Multicast