Filter
Top Products
secondary
interface
Enter the keyword secondary to configure the secondary
interface then one of the following interfaces and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number.
control-vlan
vlan-id
Enter the keyword control-vlan then the VLAN ID. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage
Information
This command causes the Ring Manager to take ownership of the two ports after
IFM validates the configuration. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not
belong to any ring.
Related
Commands
show frrp — displays the Resilient Ring Protocol configuration information.
Force10 Resilient Ring Protocol (FRRP)
785