Filter
Top Products
Parameters
rp Enter the keyword rp to upload a trace log from the Route
Processor CPU.
linecard slot-id Enter the linecard slot-id parameters to specify the
line-card CPU whose trace log you want to upload.
cmd-history Enter the keyword cmd-history to upload the command
history from the specified CPU.
hw-trace Enter the keyword hw-trace to upload the hardware trace
log from the specified CPU.
sw-trace Enter the keyword sw-trace to upload the software trace
log from the specified CPU.
Defaults None.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(1.0) Introduced on the Z9500.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
Trace log information is uploaded to flash:/TRACE_LOG_DIR.
util-threshold cpu
Configure the high or low CPU utilization thresholds for SNMP traps.
Syntax
util—threshold cpu {5sec | 1min | 5min} {cp |rp | linecard
slot–id | all} {high {0-100} | low {0-100}}
Parameters
cpu-utilization-
time
Enter one of the following values to configure the threshold
level for the time in which a Z9500 CPU can be used:
• 5sec
• 1min
• 5min
cp Enter the keyword cp to configure the CPU utilization time
for the Control Processor CPU.
rp Enter the keyword rp to configure the CPU utilization time
for the Route Processor CPU.
186
Control and Monitoring