Filter
Top Products
linecardslot-id Enter the linecard slot-id parameters to specify a
Z9500 line card. The range of slot IDs is from 0 to 2.
port-set
number
Enter the keywords port-set number parameters to
specify a port pipe (set of ports) on a line card. The range of
port-set numbers is from 0 to 3.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The port-set values are internal port numbers. For a cross reference of the internal
and port numbers, refer to the Debugging and Diagnostics chapter in the Dell
Networking OS Configuration Guide for the Z9500 System.
Example
Dell#show hardware layer2 acl eg-acl linecard 2 port-set 0
EID 0x000010ce: gid=0x10,
slice=3, slice_idx=0, part =0 prio=0x10ce,
flags=0x10202, Installed, Enabled
tcam: color_indep=0,
StageEgress
Color
Offset: 22 Width: 2
DATA=0x00000001
MASK=0x00000003
action={act=RpDrop, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 62 slice = 3 idx=0 entries=1}
{Packets}
EID 0x000010cd: gid=0x10,
slice=3, slice_idx=0x1, part =0 prio=0x10cd,
flags=0x10202, Installed, Enabled
tcam: color_indep=0,
StageEgress
OutPort
Offset: 193 Width: 7
DATA=0x00000000
MASK=0x0000007f
action={act=RpDrop, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
Debugging and Diagnostics
691