Filter
Top Products
sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Z9500
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-
address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number]
To delete a configured collector, use the no sflow collector {ip-address |
ipv6-address} agent-addr {ipv4-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number]
command.
Parameters
sflow collector
ip-address |
ipv6-address
Enter the IP address of the collector in dotted decimal
format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword agent-addr followed by the sFlow agent
IP address in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
max-
datagram-size
number
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The
default is 1400.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
1692
sFlow