Filter
Top Products
Usage
Information
Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP
address in its configuration. Only the shutdown, description, mtu, and ip mtu
commands can be configured on an interface if it is added to a Port Channel. The
mtu and ip mtu commands are only available when the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
• All members must have the same link MTU value and the same IP MTU value.
• The Port Channel link MTU and IP MTU must be less than or equal to the link
MTU and IP MTU values configured on the channel members. For example, if
the members have a link MTU of 2100 and an IP MTU 2000, the Port Channel’s
MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
When an interface is removed from a Port Channel with the no channel-member
command, the interface reverts to its configuration prior to joining the Port
Channel.
An interface can belong to only one Port Channel.
Related
Commands
description — assigns a descriptive text string to the interface.
interface port-channel — creates a Port Channel interface.
shutdown — disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Z9500
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults none
Command
Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Interfaces
893