Filter
Top Products
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results.
The show ip igmp interface command does not display information
corresponding to the loop-back interfaces.
Example
Dell#show ip igmp interface
TenGigabitEthernet 1/1 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/5 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/6 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/7 is up, line protocol is down
Internet protocol processing disabled
Vlan 20
Inbound IGMP access group is not set
Internet address is 35.0.0.1/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 125 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is enabled for all groups
IGMP activity: 0 joins
IGMP querying router is 35.0.0.1 (this system)
IGMP version is 2
show ip igmp ssm-map
Display is a list of groups that are currently in the IGMP group table and contain SSM mapped sources.
Z9500
Syntax
show ip igmp [vrf vrf-name] ssm-map [group]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group (OPTIONAL) Enter the multicast group address in the form
A.B.C.D to display the list of sources to which this group is
mapped.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Internet Group Management Protocol (IGMP)
821