Filter
Top Products
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
When this command is configured, the VLAN is operationally UP if any of the
interfaces specified in the track ip command are operationally UP, and the VLAN
is operationally DOWN if none of the tracking interfaces are operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state
depends on all the members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the
track ip command configuration.
Related
Commands
interface vlan — configures a VLAN.
tagged — specifies which interfaces in a VLAN are tagged.
1162
Layer 2