Filter
Top Products
Command
Modes
VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to associate a management port with a management VRF.
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the specified
percentage of the limit, a warning message is generated.
Valid range is 1 to 100. When warn-threshold is used, once
the limit is reached, additional dynamic routes will not be
allowed.
warning-only When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic routes
reaches the limit. Additional dynamic routes will still allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
1846
Virtual Routing and Forwarding (VRF)