Filter
Top Products
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.8.1.0 Added support for multi-topology ISIS.
7.5.1.0 Added support for SPF Throttling Enhancement.
Usage
Information
This command spf-interval in CONFIG-ROUTER-ISIS-AF-IPV6 mode is used
for IPv6 Multi-Topology route computation only. If using Single Topology mode,
use the spf-interval command in CONFIG-ROUTER-ISIS mode for both IPv4
and IPv6 route computations.
SPF throttling slows down the frequency at which route calculations are performed
during network instability. Even though throttling route calculations slows down
network convergence, not throttling can result in a network not functioning as
expected. If network topology is unstable, throttling slows down the scheduling of
route calculations until the topology regains its stability.
The first route calculation is controlled by the initial wait interval and the second
calculation is controlled by the second wait interval. Each subsequent wait interval
is twice as long as the previous one until the wait interval reaches the maximum
wait time specified (interval seconds). After the network calms down and there
are no triggers for two times the maximum interval, fast behavior is restored (the
initial wait time).
Intermediate System to Intermediate System (IS-IS)
1127