Filter
Top Products
Configuring Switching Information
135
ProSafe M5300 Switch
To configure protocol-based Auto-VoIP settings:
1. From the Prioritization Type menu, select the method used to prioritize VoIP traffic when a
call-control protocol is detected, which is one of the following:
• Remark – Remark the voice traffic with the specified 802.1p priority value at the
ingress interface.
• Traffic Class – Assign VoIP traffic to the specified traffic class when egressing the
interface.
2. From the Class Value field, select the traffic class used for protocol-based VoIP traffic. If the
Auto VoIP mode is enabled and the interface detects a call-control protocol, the switch
assigns the traffic in that session to the configured Class of Service (CoS) queue. Traffic
classes with a higher value are generally used for time-sensitive traffic. The CoS queue
associated with the specified traffic class should be configured with the appropriate
bandwidth allocation to allow priority treatment for VoIP traffic.
3. Select the check box associated with each Interface to configure, or select the check box in
the header row to apply the same settings to all interfaces.
4. From the Auto-VoIP Mode menu, select the Auto-VoIP administrative mode for the
interface.
5. Click APPLY to update the switch with the changes.
6. Click CANCEL to abandon the changes.
Field Description
Operational Status This is the operational status of the Auto-VoIP feature on the given interface.