Filter
Top Products
Configuring System Information
74
ProSafe M5300 Switch
The following table describes the Basic Stack Status fields.
Field Description
Unit ID The unit ID of the specific switch.
Switch Description The description for the unit can be configured by the user.
Serial Number The unique box serial number for this switch.
Uptime The displays the relative time since the last reboot of the switch.
Preconfigured Model Identifier This field displays the model type assigned by the device
manufacturer to identify the device.
Plugged-in Model Identifier This field displays the model type assigned by the device
manufacturer to identify the plugged-in device.
Detected Code Version This field indicates the detected version of code on this unit.
Detected Code Version in Flash The displays the Release number and version number of the code
stored in flash.
SFS Last Attempt Status This displays the status of last tried stack firmware synchronisation.
“None” is the default value if SFS has not been tried.
Stack Port Configuration
By default, the stack ports on each switch are configured for stacking. However, you can use
these ports as standard Ethernet ports. Use the Stack Port configuration page to configure
the mode of the stack ports and to view information about the ports.
To display the Stack Port Configuration page, click System
Stacking Advanced Stack
Port Configuration. A screen similar to the following is displayed (the page is shown in two
parts).