Filter
Top Products
Configuring Switching Information
142
ProSafe M5300 Switch
To configure iSCSI target settings:
1. In the TCP Port field, specify the TCP port number for the target that will monitor for
iSCSI traffic. The well-known iSCSI ports 3260 and 860 are configured as the default
ports.
2. In the IP Address field, specify an IP address for the target that will monitor for iSCSI traffic.
3. In the Target Name field, specify a name to assign to the Target.
4. Click APPLY to update the switch with the changes.
5. Click CANCEL to abandon the changes.
Sessions Detailed
Use this page to view detailed information about active iSCSI sessions.
To access the iSCSI Global Configuration page, click Switching > iSCSI > Advanced >
Sessions Detailed.
The fields on this page display the information the following table describes
Field Description
Session Index Shows the list of Session indices. The information displayed in the other
fields corresponds to the selected Session Index.
Target Name Shows the name assigned to the Target.
Initiator Name Shows the name of the initiator.
Up Time Show time that has elapsed since the session was created.
Time for aging out (in Seconds) Shows the time (in seconds) left before the session is set to expire.
ISID (Initiator Session ID) Shows the unique identifier an initiator assigns to the session endpoint.
When it is combined with the iSCSI initiator name, it provides a unique
name in the world for the SCSI initiator port.
Initiator IP Address Shows the Initiator IP Address.
Initiator TCP Port Shows the Initiator TCP Port number of one of the connections between
the Target and initiator.
Target IP Address Shows the IP Address of the Target.
Target TCP Port Shows the Target TCP Port number of one of the connections between the
Target and Initiator.