Filter
Top Products
Routing
219
ProSafe M5300 Switch
To configure a VLAN routing interface by using the VLAN Routing Wizard:
1. Use VLAN ID to specify the VLAN Identifier (VID) associated with this VLAN. The range
of the VLAN ID is 1 to 4093.
2. Use Ports to display selectable physical ports and LAGs (if any). Selected ports will be
added to the Routing VLAN. Each port has three modes:
• T (Tagged) - Select the ports on which all frames transmitted for this VLAN will be
tagged. The ports that are selected will be included in the VLAN.
• U (Untagged) - Select the ports on which all frames transmitted for this VLAN will be
untagged. The ports that are selected will be included in the VLAN.
• Blank (Autodetect) - Select the ports that may be dynamically registered in this VLAN
via GVRP. This selection has the effect of excluding a port from the selected VLAN.
3. Use the LAG Enabled option to add selected ports to VLAN as a LAG. The default is No.
4. Use IP Address to define the IP address of the VLAN interface.
5. Use Network Mask to define the subnet mask of the VLAN interface.
VLAN Routing Configuration
Use the VLAN Routing Configuration page to configure VLAN Routing interfaces on the
system.
To display the VLAN Routing Configuration page, click Routing VLAN VLAN Routing.
To configure an existing VLAN as a VLAN routing interface:
1. Use VLAN ID to enter the ID of a VLAN you want to configure for VLAN Routing. The
field will display the all IDs of the VLAN configured on this switch.
2. Use IP Address to enter the IP Address to be configured for the VLAN Routing Interface.