Filter
Top Products
Routing
292
ProSafe M5300 Switch
To configure per-interface DVMRP settings:
1. Use Interface to select the interface for which data is to be configured.
2. Use Interface Mode to set the administrative mode of the selected DVMRP routing
interface.
3. Use Interface Metric to enter the DVMRP metric for the selected interface. This value is
sent in DVMRP messages as the cost to reach this network. Valid values are from(1 to 31).
The default value is 1.
4. Click REFRESH to show the latest DVMRP interface information.
Field Description
Protocol State The operational state of the DVMRP protocol on the selected interface,
either operational or non-operational.
Local Address The IP address used as a source address in packets sent from the selected
interface.
Generation ID The DVMRP generation ID used by the router for the selected interface.
This value is reset every time an interface is (re)started and is placed in
prune messages. A change in generation ID informs the neighbor routers
that any previous information about this router should be discarded.
Received Bad Packets The number of invalid packets received on the selected interface.
Received Bad Routes The number of invalid routes received on the selected interface.
Sent Routes The number of routes sent on the selected interface.