Filter
Top Products
Configuring System Information
30
ProSafe M5300 Switch
Network Interface
From the Network Interface link, you can access the following pages:
• IPv4 Network Configuration on page 30
• IPv6 Network Interface Configuration on page 32
• IPv6 Network Interface Neighbor Table on page 33
IPv4 Network Configuration
To display the IPv4 Network Configuration page, click System > Management > Network
Interface > IPv4 Network Configuration. A screen similar to the following displays.
The network interface is the logical interface used for in-band connectivity with the switch via
any of the switch's front panel ports. The configuration parameters associated with the
switch's network interface do not affect the configuration of the front panel ports through
which traffic is switched or routed
To access the switch over a network you must first configure it with IP information (IP
address, subnet mask, and default gateway). You can configure the IP information using any
of the following:
• BOOTP
• DHCP
• Terminal interface via the EIA-232 port