Filter
Top Products
Managing Device Security
445
ProSafe M5300 Switch
4. To update an IP ACL rule, select the check box associated with the rule, update the desired
fields, and then click APPLY. You cannot modify the Rule ID of an existing IP rule.
5. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you change any of the settings on the page, click APPLY to send the updated
configuration to the switch. Configuration changes take effect immediately.
IP Extended Rules
Use these screens to configure the rules for the IP Access Control Lists created using the IP
Access Control List Configuration screen. What is shown on this screen varies depending on
the current step in the rule configuration process.
Note: There is an implicit “deny all” rule at the end of an ACL list. This
means that if an ACL is applied to a packet and if none of the explicit
rules match, then the final implicit “deny all” rule applies and the
packet is dropped.
To display the IP extended Rules page, click Security
ACL> Advanced IP Extended
Rules.
To configure rules for an IP ACL:
1. To add an IP ACL rule, select the ACL ID to add the rule to, select the check box in the
Extended ACL Rule table, and click ADD. The page displays the extended ACL Rule
Configuration fields, as the following figure shows.