Filter
Top Products
Routing
306
ProSafe M5300 Switch
PIM Interface Configuration
To display the PIM Interface Configuration page, click Routing Multicast PIM Interface
Configuration.
To configure per-interface PIM settings:
1. Select the check box associated with each interface you want to configure. Select the
check box in the heading row to apply the same settings to all interfaces.
2. Use Admin Mode to set the administrative status of PIM in the router. The default is disable.
3. Use Hello Interval (secs) to enter the time in seconds between the transmission of which
PIM Hello messages on this interface. The valid values are from 0 to 18000. The default
value is 30.
4. Use Join/Prune Interval (secs) to enter the frequency at which PIM Join/Prune messages
are transmitted on this PIM interface. The valid values are from 0 to 18000. The default
value is 60.
5. Use BSR Border to set BSR border status on the selected interface.
6. Use DR Priority to enter the DR priority for the selected interface. The valid values are from
0 to 2147483647. The default value is 1.
Field Description
Protocol State The state of PIM in the router: either operational or non-operational.
IP Address The IPv4 address of the selected PIM interface.
Designated Router The Designated Router on the selected PIM interface.
Neighbor Count The number of PIM neighbors on the selected interface.