Filter
Top Products
Configuring System Information
83
ProSafe M5300 Switch
Basic PoE Configuration
Use the PoE Configuration page to view global PoE power information and to configure PoE
settings.
To display the Basic PoE Configuration page, click System > Services > PoE > Basic > PoE
Configuration. A screen similar to the following displays.
To configure PoE trap settings:
1. If you are managing a stack of switches, select the ID of the stack member to configure
from the Unit menu.
2. Specify the percentage of the threshold power that must be consumed before a trap is sent.
3. Select the power management algorithm the switch uses to deliver power to the requesting
PDs.
• Static. The Power allocated for each port depends on the type of power threshold
configured on the port.
• Dynamic. The power consumption of each port is measured and calculated in
real-time.
4. Select the appropriate radio button to enable or disable SNMP traps for PoE.
5. Click APPLY to apply the new settings to the system.
6. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. Click REFRESH to update the screen with the current information.