Filter
Top Products
Routing
222
ProSafe M5300 Switch
Static ARP Cache
To display the Static ARP Cache page, click Routing ARP Advanced ARP Create.
ARP Static Configuration
Use this screen to add an entry to the Address Resolution Protocol table.
1. Use IP Address to enter the IP address you want to add. It must be the IP address of a
device on a subnet attached to one of the switch's existing routing interfaces.
2. Use MAC Address to specify the unicast MAC address of the device. Enter the address as
six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
3. Click ADD to add a new static ARP entry to the switch.
4. Click DELETE to delete an existing static ARP entry from the switch.
5. Click APPLY to change the MAC Address mapping to the IP. Configuration changes take
effect immediately.
ARP Cache
Use this screen to show ARP entries in the ARP Cache.
Field Description
Port The associated Unit/Slot/Port of the connection
IP Address Displays the IP address. It must be the IP address of a device on a subnet
attached to one of the switch's existing routing interfaces.
MAC Address The unicast MAC address of the device. The address is six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Click REFRESH to show the latest IP information.