Filter
Top Products
Routing
322
ProSafe M5300 Switch
MLD Routing Interface Configuration
To display the MLD Routing Interface Configuration page, click Routing IPv6 Multicast
MLD Routing Interface Configuration.
To configure per-interface MLD settings:
1. Use Interface to select the interface for which data is to be configured or displayed.
2. Use Admin Mode to set the administrative status of MLD on the selected interface. The
default value is disable.
3. Use Version to enter the version to be configured on the selected interface. Valid values
are(1 to 2). The default value is 2.
4. Use Query Interval to enter the frequency in seconds at which MLD host-query packets are
to be transmitted on this interface. Valid values are from 1 to 1800. The default value is 125.
5. Use Query Max Response Time to enter the maximum query response time to be
advertised in MLDv2 queries on this interface, in milliseconds. Valid values are from 0 to
65535. The default value is 10000 milliseconds.
6. Use Robustness to specify the robustness parameter for the selected interface. This
variable allows tuning for the expected packet loss on a subnet. If a subnet is expected to be
lossy, the robustness variable may be increased. MLD is robust to (robustness variable-1)
packet losses.
7. Use Startup Query Interval to specify the value that indicates the configured interval (in
seconds) between General Queries sent by a Querier on startup.