Filter
Top Products
Routing
244
ProSafe M5300 Switch
12. Use Authentication Type to select an authentication type other than none. You can select
the authentication type from the pull-down menu. The choices are:
• None: This is the initial interface state. If you select this option from the pull-down
menu, no authentication protocols will be run.
• Simple - If you select 'Simple' you will be prompted to enter an authentication key.
This key will be included, in the clear, in the OSPF header of all packets sent on the
network. All routers on the network must be configured with the same key.
• Encrypt - If you select 'Encrypt' you will be prompted to enter both an authentication
key and an authentication ID. Encryption uses the MD5 Message-Digest algorithm. All
routers on the network must be configured with the same key and ID.
13. Use Authentication Key to enter the OSPF Authentication Key for the specified interface. If
you do not choose to use authentication you will not be prompted to enter a key. If you
choose 'simple' authentication you cannot use a key of more than eight octets. If you choose
'encrypt' the key may be up to 16 octets long. The key value will only be displayed if you are
logged on with Read/Write privileges, otherwise it will be displayed as asterisks.
14. Use Authentication Key ID to enter the ID to be used for authentication. You will only be
prompted to enter an ID when you select 'Encrypt' as the authentication type. The ID is a
number between 0 ad 255, inclusive.
15. Use Metric Cost to enter the link cost. OSPF uses this value in computing shortest paths.
The range is from 1 to 65,535.
16. Click APPLY to update the switch with the configured settings.
17. Click CANCEL to abandon the changes.
Field Description
IP Address The IP address of the interface.
Subnet Mask The network mask, indicating the portion of the IP address that identifies
the attached network.
LSA Ack Intervlan (secs) The number of seconds to wait before sending a delayed
acknowledgement.