Filter
Top Products
Managing Device Security
420
ProSafe M5300 Switch
IP Source Guard Interface Configuration
To display the IP Source Guard Interface Configuration page, click Security Control> IP
Source Guard
Interface Configuration.
To configure interfaces for IPSG:
1. Select the check box associated with each interface to configure. To apply the same
settings to all interfaces, select the check box in the header row.
2. Use IPSG Mode to enable or disable validation of Sender IP Address on this interface. If
IPSG is Enabled Packets will not be forwarded if Sender IP Address is not in DHCP
Snooping Binding database. The factory default is disabled.
3. Use IPSG Port Security to enable or disables the IPSG Port Security on the selected
interface. If IPSG Port Security is enabled then the packets will not be forwarded if the
sender MAC Address is not in FDB table and it is not in DHCP snooping binding database.
To enforce filtering based on MAC address other required configurations are:
• Enable port-security globally.
• Enable port-security on the interface level.
IPSG Port Security can't be Enabled if IPSG is Disabled. The factory default is disabled.
IP Source Guard Binding Configuration
To display the IP Source Guard Binding Configuration page, click Security Control> IP
Source Guard
Binding Configuration.