Filter
Top Products
Configuring Switching Information
168
ProSafe M5300 Switch
MLD Snooping Interface Configuration
To access the MLD Snooping Interface Configuration page, click Switching Multicast
MLD Snooping
Interface Configuration.
1. Select the check box associated with each interface you want to configure. Select the
check box in the heading row to apply the same settings to all interfaces.
2. Use Admin Mode to select the interface mode for the selected interface for MLD Snooping
for the switch. The default is disable.
3. Use Group Membership Interval (secs) to specify the amount of time you want the switch
to wait for a report for a particular group on a particular interface before it deletes that
interface from the group. The valid range is from (2 to 3600) seconds. The configured value
must be greater than Max Response Time. The default is 260 seconds.
4. Use Max Response Time (secs) to specify the amount of time you want the switch to wait
after sending a query on an interface because it did not receive a report for a particular
group on that interface. Enter a value greater or equal to 1 and less than the Group
Membership Interval in seconds. The default is 10 seconds. The configured value must be
less than the Group Membership Interval.
5. Use Present Expiration Time to specify the amount of time you want the switch to wait to
receive a query on an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A
value of zero indicates an infinite time-out, i.e. no expiration.
6. Use Fast Leave Admin mode to select the Fast Leave mode for the a particular interface
from the pull-down menu. The default is disable.
7. Click APPLY to apply the new settings to the switch. Configuration changes take effect
immediately
8. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.