Filter
Top Products
Managing Device Security
440
ProSafe M5300 Switch
MAC Binding Configuration
When an ACL is bound to an interface, all the rules that have been defined are applied to the
selected interface. Use the MAC Binding Configuration page to assign MAC ACL lists to ACL
Priorities and Interfaces.
To display the MAC Binding Configuration page, click Security
ACL> Basic MAC Binding
Configuration.
1. Select an existing MAC ACL from the ACL ID menu. You can select one and bind it to
the interfaces you wanted.
The packet filtering direction for ACL is Inbound, which means the MAC ACL rules are
applied to traffic entering the port.
2. Specify an optional sequence number to indicate the order of this access list relative to other
access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
3. Click the appropriate orange bar to expose the available ports or LAGs. The Port Selection
Table provides a list of all available valid interfaces for ACL binding. All non-routing physical
interfaces, VLAN interface and interfaces participating in LAGs are listed.
• To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
• To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
4. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.