Filter
Top Products
Routing
232
ProSafe M5300 Switch
OSPF
Note: OSPF is a licensed feature and is available only on switches that
have an active license installed.
From the OSPF link, you can access the following pages:
• Basic on page 232
• Advanced on page 233
Basic
From the Basic link, you can access the following pages:
• OSPF Configuration (Basic) on page 232
OSPF Configuration (Basic)
Use the OSPF Configuration page to enable OSPF on a router and to configure the related
OSPF settings.
To display the OSPF Configuration page, click Routing OSPF Basic OSPF
Configuration.
To configure the administrative mode of OSPF on the switch:
1. Use Router ID to specify a 32-bit integer in dotted decimal format that uniquely identifies
the router within the autonomous system (AS). To change the Router ID you must first
disable OSPF. After you set the new Router ID, you must re-enable OSPF to have the
change take effect. The default value is 0.0.0.0, although this is not a valid Router ID.
2. Use Admin Mode to select enable or disable. If you select enable, OSPF will be activated
for the switch. The default value is disable. You must configure a Router ID before OSPF
can become operational; see step 1 or by issuing the CLI command:
(Config-router)#router-id.
3. Click APPLY to update the switch with the changes.
4. Click CANCEL to abandon the changes.