Filter
Top Products
Routing
193
ProSafe M5300 Switch
IP
The IP folder contains links to the following web pages that configure and display IP routing
data:
• Basic on page 193
• Advanced on page 197
Basic
From the Basic link, you can access the following pages:
• IP Configuration on page 193
• Statistics on page 194
IP Configuration
Use this menu to configure routing parameters for the switch, as opposed to an interface.
To display the IP Configuration page, click Routing
IP Basic IP Configuration.
To configure global IP routing:
1. Use Routing Mode to select enable or disable. You must enable routing for the switch
before you can route through any of the interfaces. The default value is disable.
2. Use ICMP Echo Replies to select enable or disable. If it is enable then only the router can
send ECHO replies. By default ICMP Echo Replies are sent for echo requests.
3. Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface
level then only the router can send ICMP Redirects.
4. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number
of ICMP error packets that are allowed per burst interval. By default, Rate limit is 100
packets/sec i.e., burst interval is 1000 msec. To disable ICMP Rate limiting, set this field to
'0'. Valid Rate Interval must be in the range 0 to 2147483647.