Filter
Top Products
Configuring System Information
42
ProSafe M5300 Switch
The Dynamic Host Mapping table shows host name-to-IP address entries that the switch has
learned. The following table describes the dynamic host fields.
Field Description
Host Lists the host name you assign to the specified IP address.
Total Amount of time since the dynamic entry was first added to the table.
Elapsed Amount of time since the dynamic entry was last updated.
Type The type of the dynamic entry.
Addresses Lists the IP address associated with the host name.
SDM Template Preference
You can use this page to configure the Switch Database Management (SDM) template that is
active after the next reboot. An SDM template is a description of the maximum resources the
device can use for various features. Different SDM templates allow different combinations of
scaling factors, enabling different allocations of resources depending on how the device is
used. In other words, SDM templates enable you to reallocate system resources to support a
different mix of features based on your network requirements.
To access this page, click System
Management DNS SDM Template Preference.
To configure the SDM Template Preference settings:
1. Use SDM Current Template ID to view the SDM template the switch is currently using.
2. Use SDM Next Template ID to configure the next active template. It will be active only after
the next reboot. To revert to the default template after the next reboot, use the Default
option. Possible values are:
• Default
• Dual IPv4 and IPv6
• IPv4-routing Default
• IPv4 Data Center