Filter
Top Products
Routing
265
ProSafe M5300 Switch
Area Range Configuration
Use the Area Range Configuration page to configure OSPFv3 area ranges.
To display the Area Range Configuration page, click Routing OSPFv3 Advanced Area
Range Configuration.
1. Use Area ID to specify the area for which data is to be configured.
2. Use IPv6 Prefix to enter the IPv6 Prefix/Prefix Length for the address range for the selected
area.
3. Use LSDB Type to select the type of Link Advertisement associated with the specified area
and address range. The default type is 'Network Summary'.
4. Use Advertise to select Enable or Disable. If you select Enable, the address range will be
advertised outside the area via a Network Summary LSA. The default is Enable.
5. Click ADD to add the new address range to the switch.
6. Click DELETE to remove the specified address range from the area configuration.
Area LSA Count The total number of link-state advertisements in this area's link-state
database, excluding AS External LSAs.
Area LSA Checksum The 32-bit unsigned sum of the link-state advertisements' LS checksums
contained in this area's link-state database. This sum excludes external (LS
type 5) link-state advertisements. The sum can be used to determine if there
has been a change in a router's link state database, and to compare the
link-state database of two routers.
Translator State
Translator State 'Enabled' means that the NSSA router OSPFv3 Area NssA
Translator Role has been set to always. Translator State of 'Elected' means a
candidate NSSA Border router is translating type-7 LSAs into type-5.'
Disabled' implies that a candidate NSSA Border router is NOT translating
type-7 LSAs into type-5.
Field Description