NETGEAR GS728TP100NAS Switch User Manual


 
Routing
290
ProSafe M5300 Switch
DVMRP
DVMRP is an interior gateway protocol that is suitable for routing multicast traffic within an
autonomous system (AS). DVMRP should not be used between different autonomous
systems due to limitations with hop count and scalability.
Note: Only one multicast routing protocol can be operational on the switch
at any time. If you enable DVMRP, PIM must be disabled. Similarly, if
PIM is enabled, DVMRP must be disabled.
DVMRP exchanges probe packets with all its DVMRP-enabled routers, it establishes
two-way neighboring relationships, and it builds a neighbor table. DVMRP exchanges report
packets and creates a unicast topology table, with which it builds the multicast routing table.
This table is used to route the multicast packets. Since every DVMRP router uses the same
unicast routing protocol, routing loops are avoided.
From the DVMRP link, you can access the following pages:
DVMRP Global Configuration on page 291
DVMRP Interface Configuration on page 291
DVMRP Neighbor on page 293
DVMRP Next Hop on page 294
DVMRP Prune on page 294
DVMRP Route on page 295