Filter
Top Products
Rev. 1.00, 05/04, page 69 of 544
5.3 Register Descriptions
The interrupt controller has the following registers. For details on the system control register
(SYSCR), refer to section 3.2.2, System Control Register (SYSCR).
• Interrupt control registers A to C (ICRA to ICRC)
• Address break control register (ABRKCR)
• Break address registers A to C (BARA to BARC)
• IRQ sense control registers (ISCRH, ISCRL)
• IRQ enable register (IER)
• IRQ status register (ISR)
• Keyboard matrix interrupt mask registers (KMIMRA, KMIMR)
• Wake-up event interrupt mask register (WUEMRB)
5.3.1 Interrupt Control Registers A to C (ICRA to ICRC)
The ICR registers set interrupt control levels for interrupts other than NMI and address breaks.
The correspondence between interrupt sources and ICRA to ICRC settings is shown in table 5.2.
Bit Bit Name
Initial
Value
R/W Description
7 to 0 ICRn7 to
IRCn0
All 0 R/W Interrupt Control Level
0: Corresponding interrupt source is interrupt control
level 0 (no priority)
1: Corresponding interrupt source is interrupt control
level 1 (priority)
[Legend]
n: A to C