Renesas H8S/2111B Network Card User Manual


 
Rev. 1.00, 05/04, page 403 of 544
The scope of the initialization in each mode is shown in table 15.6.
Table 15.6 Scope of Initialization in Each Host Interface Mode
Items Initialized
System
Reset LPC Reset
LPC
Shutdown
LPC transfer cycle sequencer (internal state), LPCBSY and
ABRT flags
Initialized Initialized Initialized
SERIRQ transfer cycle sequencer (internal state), CLKREQ and
IRQBSY flags
Initialized Initialized Initialized
Host interface flags
(IBF1, IBF2, IBF3A, IBF3B, MWMF, C/D1, C/D2, C/D3, OBF1,
OBF2, OBF3A, OBF3B, SWMF, DBU), GA20 (internal state)
Initialized Initialized Retained
Host interrupt enable bits
(IRQ1E1, IRQ12E1, SMIE2, IRQ6E2,
IRQ9E2 to IRQ11E2, SMIE3B, SMIE3A, IRQ6E3, IRQ9E3 to
IRQ11E3), Q/C flag, SELREQ bit
Initialized Initialized Retained
LRST flag Initialized
(0)
Can be
set/cleared
Can be
set/cleared
SDWN flag Initialized
(0)
Initialized
(0)
Can be
set/cleared
LRSTB bit Initialized
(0)
HR: 0
SR: 1
0 (can be set)
SDWNB bit Initialized
(0)
Initialized
(0)
HS: 0
SS: 1
SDWNE bit Initialized
(0)
Initialized
(0)
HS: 1
SS: 0 or 1
Host interface operation control bits
(LPC3E to LPC1E, FGA20E, LADR3,
IBFIE1 to IBFIE3, PMEE, PMEB, LSMIE, LSMIB, LSCIE, LSCIB,
TWRE, SELSTR3, SELIRQ1, SELSMI, SELIRQ6, SELIRQ9,
SELIRQ10, SELIRQ11, SELIRQ12)
Initialized Retained Retained
LRESET signal Input (port
function
Input Input
LPCPD signal Input Input
LAD3 to LAD0, LFRAME, LCLK, SERIRQ,
CLKRUN signals
Input Hi-Z
PME, LSMI, LSCI, GA20 signals (when function is selected) Output Hi-Z
PME, LSMI, LSCI, GA20 signals (when function is not selected) Port function Port function
Note: System reset: Reset by STBY input, RES input, or WDT overflow
LPC reset: Reset by LPC hardware reset (HR) or LPC software reset (SR)
LPC shutdown: Reset by LPC hardware shutdown (HS) or LPC software shutdown (SS)