Renesas H8S/2111B Network Card User Manual


 
Rev. 1.00, 05/04, page 408 of 544
15.5 Interrupt Sources
15.5.1 IBFI1, IBFI2, IBFI3, and ERRI
The host interface has four interrupt requests for the slave processor (this LSI): IBF1, IBF2, IBF3,
and ERRI. IBFI1, IBFI2, and IBFI3 are IDR receive complete interrupts for IDR1, IDR2, and
IDR3 and TWR, respectively. The ERRI interrupt indicates the occurrence of a special state such
as an LPC reset, LPC shutdown, or transfer cycle abort. An interrupt request is enabled by setting
the corresponding enable bit.
Table 15.7 Receive Complete Interrupts and Error Interrupt
Interrupt Description
IBFI1 When IBFIE1 is set to 1 and IDR1 reception is completed
IBFI2 When IBFIE2 is set to 1 and IDR2 reception is completed
IBFI3 When IBFIE3 is set to 1 and IDR3 reception is completed, or when TWRE and
IBFIE3 are set to 1 and reception is completed up to TWR15
ERRI When ERRIE is set to 1 and one of LRST, SDWN and ABRT is set to 1
15.5.2 SMI, HIRQ1, HIRQ6, HIRQ9, HIRQ10, HIRQ11, and HIRQ12
The host interface can request seven kinds of host interrupt by means of SERIRQ. HIRQ1 and
HIRQ12 are used on LPC channel 1 only, while SMI, HIRQ6, HIRQ9, HIRQ10, and HIRQ11 can
be requested from LPC channel 2 or 3.
There are two ways of clearing a host interrupt request.
When the IEDIR bit is cleared to 0 in SIRQCR0, host interrupt sources and LPC channels are all
linked to the host interrupt request enable bits. When the OBF flag is cleared to 0 by a read of
ODR or TWR15 by the host in the corresponding LPC channel, the corresponding host interrupt
enable bit is automatically cleared to 0, and the host interrupt request is cleared.
When the IEDIR bit is set to 1 in SIRQCR0, LPC channel 2 and 3 interrupt requests are dependent
only upon the host interrupt enable bits. The host interrupt enable bit is not cleared when OBF for
channel 2 or 3 is cleared. Therefore, SMIE2, SMIE3A and SMIE3B, IRQ6E2 and IRQ6E3,
IRQ9E2 and IRQ9E3, IRQ10E2 and IRQ10E3, and IRQ11E2 and IRQ11E3 lose their respective
functional differences. In order to clear a host interrupt request, it is necessary to clear the host
interrupt enable bit.