D-Link DGS-3600 Switch User Manual


 
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
112
DGS-3600:4#show 802.1p user_priority
Command: show 802.1p user_priority
QOS Class of Traffic
Priority-0 -> <Class-2>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>
Priority-6 -> <Class-6>
Priority-7 -> <Class-6>
DGS-3600:4#
config 802.1p default_priority
Purpose Used to configure the 802.1p default priority settings on the Switch. If
an untagged packet is received by the Switch, the priority configured
with this command will be written to the packet’s priority field.
Syntax
config 802.1p default_priority [<portlist> | all] <priority 0-7>
Description This command allows users to specify default priority handling of
untagged packets received by the Switch. The priority value entered
with this command will be used to determine to which of the seven
hardware priority queues the packet is forwarded.
Parameters
<portlist> Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4
in numerical order. Non-contiguous portlist entries are separated by
a comma. (ex: 1:1-1:3,1:7-1:9)
all Specifies that the command applies to all ports on the Switch.
<priority 0-7> The priority value to assign to untagged packets
received by the Switch or a range of ports on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1p default priority on the Switch:
DGS-3600:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DGS-3600:4#