Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
374
DGS-3600:4#delete server_group group_1
Command: delete server_group group_1
Success.
DGS-3600:4#
show authen server_group
Purpose Used to view authentication server groups on the Switch.
Syntax
show authen server_group <string 15>
Description This command will display authentication server groups currently
configured on the Switch.
This command will display the following fields:
Group Name: The name of the server group currently configured on
the Switch, including built in groups and user defined groups.
IP Address: The IP address of the server host.
Protocol: The authentication protocol used by the server host.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be viewed.
Entering this command without the <string> parameter will display all
authentication server groups on the Switch.
Restrictions None.
Example usage:
To view authentication server groups currently set on the Switch.
DGS-3600:4#show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
--------------- --------------- --------
Darren 10.53.13.2 TACACS
tacacs 10.53.13.94 TACACS
tacacs+ ---------------------------------------------------------
xtacacs ---------------------------------------------------------
Total Entries : 4
DGS-3600:4#
config authen parameter response_timeout
Purpose Used to configure the amount of time the Switch will wait for a user
to enter authentication before timing out.
Syntax
config authen parameter response_timeout <int 0-255>
Description This command will set the time the Switch will wait for a response of
authentication from the user.
Parameters response_timeout <int 0-255> - Set the time, in seconds, the Switch
will wait for a response of authentication from the user attempting to
log in from the command line interface or telnet interface. 0 disables
the timeout for the response. The default value is 30 seconds.
Restrictions Only administrator-level users can issue this command.