Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
9
4
BASIC SWITCH COMMANDS
The basic switch commands in the Command Line Interface (CLI) are listed (with the appropriate parameters) in the following table.
Command Parameters
create account [admin | user] <username 15>
config account <username>
show account
delete account <username>
show session
show switch
show serial_port
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
enable clipaging
disable clipaging
enable telnet <tcp_port_number 1-65535>
disable telnet
enable web <tcp_port_number 1-65535>
disable web
save {[config {<drive_id>} <pathname 64> | log | all]}
reboot
reset {[config | system]}
login
logout
show device status
show module_info
config greeting_message {default}
show greeting_message
Each command is listed, in detail, in the following sections.
create account
Purpose
Used to create user accounts.
Syntax create [admin | user] <username 15>
Description
The create account command is used to create user accounts that consist of a
username of 1 to 15 characters and a password of 0 to 15 characters. Up to eight
user accounts can be created.
Parameters
admin <username 15> - Enter a name between 1 and 15 alphanumeric characters
to define the administrator account created here.
user <username 15>- Enter a name between 1 and 15 alphanumeric characters
to define the user account created here.