Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
20
config command_prompt
Only administrator-level users can issue this command.
Example usage:
To configure the command prompt:
DGS-3600:4#config command prompt Trinity
Command: config command prompt Trinity
Success.
Trinity#
config greeting_message
Purpose Used to configure the greeting message or banner for the opening
screen of the Command Line Interface.
Syntax
config greeting_message {default}
Description This command is used to configure the greeting message or login
banner for the opening screen of the CLI.
Parameters default – Adding this parameter will return the greeting command to its
original factory default configuration.
Restrictions The reset command will not alter the configured greeting message, yet
the reset system command will return the greeting message to its
original factory default setting.
The maximum character capacity for the greeting banned is 6 lines and
80 characters per line. Entering Ctrl+W will save the current configured
banner to the DRAM only. To save it into the FLASH memory, the user
must enter the save command.
Only administrator-level users can issue this command.
Example usage:
To configure the greeting message:
DGS-3600:4#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
DGS-3600 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.20.B35
Copyright(C) 2007 D-Link Corporation. All rights reserved.
===============================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
------------------------------------------------------------------------------------------------------------------------------------------
Success.
DGS-3600:4#