Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
290
delete ipv6route
Parameters default – Use this parameter to delete a default static IPv6 route entry to the
Switch’s IP routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is
the destination of the route. Specify the address and mask information using
the format as ipv6address / prefix_length (ipv6address is hexadecimal
number, prefix length is decimal number, for example 1234::5D7F/32).
<ipif_name 12> - Enter the corresponding IP interface name of the IPv6
address to be deleted here.
<ipv6addr> − IPv6 address for the next hop router.
all − This will delete all IPv6 static entries.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a static IPv6 entry from the routing table:
DGS-3600:4# delete ipv6route 1234::5D7F/32 2D30::AC21
Command: delete ipv6route 1234::5D7F/32 2D30::AC21
Success.
DGS-3600:4#
show ipv6route
Purpose Used to display the Switch’s current static IPv6 routing table or a
specified IPv6 address.
Syntax
show ipv6route {<ipv6networkaddr>}
Description This command will display the Switch’s current static IPv6 routing table
or a specific IPv6 entry.
Parameters
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask
information using the format as ipv6address / prefix_length
(ipv6address is hexadecimal number, prefix length is decimal number,
for example 1234::5D7F/32).
Restrictions None.
Example usage:
To display the static IPv6 entries in the routing table:
DGS-3600:4# show ipv6route
Command: show ipv6route
IPv6 Prefix : ::/0 Protocol : Static Metric: 65535
Next Hop : 3003::30 IPIF : ip3
Backup : Backup Status : Active
Total Entries : 1
DGS-3600:4#