Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
53
8
SWITCH UTILITY COMMANDS (INCLUDING FILE SYSTEM COMMANDS)
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename 64> {{{unit
[<unitid 1-12> | all]} <drive_id>} <pathname 64> {boot_up}} | cfg_fromTFTP
[<ipaddr> | <ipv6addr>] <path_filename 64> {{<drive_id>} {<pathname 64>}]
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>{{<drive_id>}
<pathname 64>} | log_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
| firmware_toTFTP[<ipaddr> | <ipv6addr>] <path_filename 64>
{{<drive_id>} <pathname 64>} | attack_log_toTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64> {unit <unit_id 1-12>} ]
config firmware image {{unit [<unitid 1-12> | all]} <drive_id>} <pathname 64> boot_up
show config [active | bootup | {<drive_id>} <pathname 64>]
config configuration {<drive_id>} <pathname 64> [boot_up | active]
erase {{unit <unitid 1-12>} <drive_id> <pathname 64>
rename {{unit <unitid 1-12>} <drive_id>} <pathname 64> <filename 64>
dir {{unit [<unitid 1-12> | all]} {<drive_id>}
copy {<drive_id>} <pathname 64> {{unit <unit_id 1-12>} <drive_id>} <pathname
64>
show boot_file {{unit <unitid 1-12> | all]}
show storage_media_info {{unit <unitid 1-12> | all]}
config file_system_version <version_number 1-2> {<string>}
ping
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000> | timeout <sec 1-
10>}
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <value 1-
65535> | probe <value 1-9>}
enable autoconfig
disable autoconfig
show autoconfig
Each command is listed, in detail, in the following sections.
download
Purpose Used to download and install new firmware or a Switch configuration file from a TFTP
server.
Syntax download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename 64> {{{unit
[<unitid 1-12> | all]} <drive_id>} <pathname 64> {boot_up}} | cfg_fromTFTP
[<ipaddr> | <ipv6addr>] <path_filename 64> {{<drive_id>} {<pathname 64>}]
Description This command is used to download a new firmware or a Switch configuration file from a
TFTP server. The user now has the option of saving the firmware or configuration file on
the flash memory located in the Switch using the previously allocated c:\ drive.