Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
133
config port dot1v
Purpose Used to bind a VLAN with a protocol template on one or more ports.
Syntax
config port dot1v ports [<portlist> | all] [add protocol_group group_id
<id> vlan vlan_name <vlan_name 32> | delete protocol_group
[group_id <id> | all]]
Description This command will bind a VLAN with a protocol template on one or more
ports. When an ingress untagged packet is identified by the protocol_value
stated using the config dot1v_protocol_group command, the switch will
assign a pre-configured VLAN and a priority for these ingress untagged
packets in order to properly reach their destination.
Parameters ports – Use this parameter to specify ports.
• <portlist> - Use this parameter to assign a port or group of ports.
• all – Use this parameter to specify all ports on the system.
add protocol_group group_id <id> - Enter an integer from 1-16 to identify
the protocol VLAN group being assigned to the ports or range of ports
configured in the previous field.
vlan – Use this parameter bind a VLAN with a specific protocol template
using either of the following parameters:
• vlan_name 32 – Identify the VLAN name for which to add a tag
to ingress untagged packets.
delete protocol_group – Use this parameter to remove this protocol VLAN
group’s association with the ports stated in this command, by using the
following parameters:
• group_id <id> - Enter this parameter with its corresponding
group number, to remove this pre-defined protocol group from
the ports specified here.
• all – Use this parameter to remove all protocol VLAN groups
from the ports specified in this command.
Restrictions Only administrator-level users can issue this command.
Example usage:
To bind a VLAN with a protocol template:
DGS-3600:4#config port dot1v ports 6-8 add protocol_group group_id 1 vlan vlan_name
building1
Command: config port dot1v ports 6-8 add protocol_group group_id 1 vlan vlan_name
building1
Success.
DGS-3600:4#