Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
342
config ospf virtual_link
<neighbor_id> − The OSPF router ID for the remote area. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area’s Area Border Router.
hello_interval <sec 1-65535> − Allows the specification of the interval
between the transmission of OSPF Hello packets, in seconds. Between 1
and 65535 seconds can be specified. The Hello Interval, Dead Interval,
Authorization Type, and Authorization Key should be the same for all
routers on the same network.
dead_interval <sec 1-65535> − Allows the specification of the length of
time between the receipt of Hello packets from a neighbor router before
the selected area declares that router down. An interval between 1 and
65535 seconds can be specified. The Dead Interval must be evenly
divisible by the Hello Interval.
authentication – Enter the type of authentication preferred. The user may
choose between:
• none – Choosing this parameter will require no authentication.
• simple <password 8> − Choosing this parameter will set a simple
authentication which includes a case-sensitive password of no
more than 8 characters.
• md5 <key_id 1-255> − Choosing this parameter will set
authentication based on md5 encryption. A previously configured
MD5 key ID (1 to 255) is required.
Restrictions Only administrator-level users can issue this command.
Usage example
To configure the OSPF virtual interface settings:
DGS-3600:4#config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Command: config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Success.
DGS-3600:4#
delete ospf virtual_link
Purpose Used to delete an OSPF virtual interface.
Syntax
delete ospf virtual_link <area_id> <neighbor_id>
Description This command will delete an OSPF virtual interface from the Switch.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<neighbor_id> − The OSPF router ID for the remote area. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area’s Area Border Router. The router ID of the
neighbor router.
Restrictions Only administrator-level users can issue this command.
Usage example:
To delete an OSPF virtual interface from the Switch: