Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
327
46
OSPF CONFIGURATION COMMANDS
The OSPF configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ospf router_id <ipaddr>
enable ospf
disable ospf
show ospf {ipif <ipif_name 12> | all}
create ospf area <area_id> type [normal | [stub | nssa {translate [enable | disable]}]
{stub_summary [enable | disable] | metric <value 0-65535>}]
delete ospf area <area_id>
config ospf area <area_id> type [normal | [stub | nssa {translate [enable | disable]}]
{stub_summary [enable | disable] | metric <value 0-65535>}]
show ospf area {<area_id>}
create ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}
delete ospf host_route <ipaddr>
config ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}
show ospf host_route <ipaddr>
create ospf aggregation <area_id> <network_address> lsdb_type [summary {advertise [enable |
disable]} | nssa_ext {advertise [enable | disable]}]
delete ospf aggregation <area_id> <network_address> lsdb_type [summary | nssa_ext]
config ospf aggregation <area_id> <network_address> lsdb_type [summary {advertise [enable |
disable]} | nssa_ext {advertise [enable | disable]}]
show ospf aggregation {<area_id>}
show ospf lsdb {area <area_id> | advertise_router <ipaddr> | type [rtrlink | netlink | summary |
assummary | asextlink | nssa_ext]}
show ospf neighbor {<ipaddr>}
show ospf virtual_neighbor {<area_id> <neighbor_id>}
config ospf ipif [ipif <ipif_name 12> | all] {area <area_id> | priority <value> | hello_interval
<sec 1-65535> | dead_interval <sec 1-65535> | authentication [none | simple
<password 8> | md5 <key_id 1-255>] | metric <value 1-65535> | state [enable
| disable] | passive [enable | disable]}
create ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec
1-65535> | authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
config ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec
1-65535> | authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
delete ospf virtual_link <area_id> <neighbor_id>
show ospf virtual_link {<area_id> <neighbor_id>}
Each command is listed, in detail, in the following sections.